|
| |
 |
|
|
Inline Turbine Flowmeter (TFM Series) |
|
|
|
Rockwin Turbine Flowmeters are designed to provide a high order of accuracy & reliability under the severest conditions encountered in Oil, Gas, Petrochemical, Aerospace and other industries. These flowmeters are precise, reliable, rugged and built to international standards. Sizes range from 5 to 500 mm with flanged end connections and 5 to 50 mm with threaded end connections. All flowmeters are individually calibrated on Rockwin's In-house Certified Calibration Laboratory.
|
|
|
General Specifications:
| PARAMETER |
METERS FOR LIQUIDS |
METERS FOR GASES |
| Flow Range |
upto 7000 M³/Hr |
Upto 17000 AM³/Hr |
| Accuracy |
Linearity: +/- 0.5% over 10% to 100% Flow Range.
: +/- 0.25% for 50 mm and above
Repeatability: +/- 0.02%
(95% confidence level) |
+/- 1% over 10% to 100% Flow Range (inclusive of linearity and repeatability) |
| Max. Pressure |
Threaded Meters: 250 kg/cm²(4000 p.s.i.).
Higher rating meters available on request.
Flanged meters: According to flange rating |
Threaded Meters:
250 kg/cm² (4000 p.s.i.). Higher rating meters available on request.
Flanged meters: According to flange rating |
| Pressure Drop |
Approx. 0.28 kg/cm² (4 psi) at maximum flow
(Specific Gravity 1, Viscosity 1 cst) |
Approx. 1 inch w.g. at maximum flow
(Air Specific Gravity 1 ) |
| Temperature Range |
Tungsten Carbide/Stellite:
-50°C to +250°C
Shielded Ball Bearings: -50°C to +250°C |
Shielded Ball bearings:
-50°C to +150°C |
| Electrical Connections |
MS type Amphenol connector supplied with matting connector or conduit box with terminal block connections (conduit box specification dependent on certification requirements). |
| Field Electronics |
A range of Pre-amplifiers, F/I converters and local display electronics are available. |
|
|
|
|
|
|
|
